New update Lead4Pass 300-710 Dumps with PDF and VCE|300-710 SNCF Exam

New updated Lead4Pass 300-710 Dumps with PDF file and VCE practice exam engine to help pass the 300-710 SNCF Exam successfully!

Lead4Pass 300-710 exam dumps contain 238 exam questions and answers, covering complete CCNP Security 300-710 SNCF certification exam questions, and verified to be true and valid, check here to get the latest Lead4Pass 300-710 dumps: https://www.leads4pass.com/300-710.html (PDF+VCE).

And, download a partial Lead4Pass 300-710 dumps from Google Drive: https://drive.google.com/file/d/19SSHJ74oetyFIw850DzQL9WkIEtlCyl4/

Also, read the latest 13 Lead4Pass 300-710 dumps exam questions and answers online:

Number of exam questionsExam nameFromRelease timePrevious issue
13Securing Networks with Cisco Firepower (SNCF)Lead4passNov 21, 2022[Updated Sep 2022] 300-710 dumps exam questions
NEW QUESTION 1:

A network security engineer must replace a faulty Cisco FTD device in a high-availability pair. Which action must be
taken while replacing the faulty unit?

A. Ensure that the faulty Cisco FTD device remains registered to the Cisco FMC
B. Shut down the active Cisco FTD device before powering up the replacement unit
C. Shut down the Cisco FMC before powering up the replacement unit
D. Unregister the faulty Cisco FTD device from the Cisco FMC

Correct Answer: D

NEW QUESTION 2:

A network engineer is tasked with minimizing traffic interruption during peak traffic limes. When the SNORT inspection
the engine is overwhelmed, what must be configured to alleviate this issue?

A. Enable IPS inline link state propagation
B. Enable Pre-filter policies before the SNORT engine failure.
C. Set a Trust ALL access control policy.
D. Enable Automatic Application Bypass.

Correct Answer: D

NEW QUESTION 3:

Refer to the exhibit

new 300-710 dumps exam questions 3

An engineer is modifying an access control pokey to add a rule to inspect all DNS traffic that passes through the firewall
After making the change and deploying the pokey they see that DNS traffic is not bang inspected by the Snort engine
What is the problem?

A. The rule must specify the security zone that originates the traffic.
B. The rule Is configured with the wrong setting for the source port.
C. The rule must define the source network for inspection as well as the port.
D. The action of the rule is set to trust instead of allow.

Correct Answer: D

NEW QUESTION 4:

Which two dynamic routing protocols are supported in Firepower Threat Defense without using FlexConfig? (Choose
two.)

A. EIGRP
B. OSPF
C. static routing
D. IS-IS
E. BGP

Correct Answer: BE

Reference: https://www.cisco.com/c/en/us/td/docs/security/firepower/660/fdm/fptd-fdm-config-guide-660/fptd-fdm-
routing.html

NEW QUESTION 5:

An organization has seen a lot of traffic congestion on their links going out to the internet. There is a Cisco Firepower
device that processes all of the traffic going to the internet prior to leaving the enterprise. How is the congestion
alleviated so that legitimate business traffic reaches the destination?

A. Create a NAT policy so that the Cisco Firepower device does not have to translate as many addresses.
B. Create a flexconfig policy to use WCCP for application-aware bandwidth limiting.
C. Create a QoS policy rate-limiting high bandwidth applications.
D. Create a VPN policy so that direct tunnels are established to the business applications.

Correct Answer: C

NEW QUESTION 6:

An administrator Is setting up a Cisco PMC and must provide expert mode access for a security engineer. The engineer
Is permitted to use only a secured out-of-band network workstation with a static IP address to access the Cisco FMC.
What must be configured to enable this access?

A. Enable SSH and define an access list.
B. Enable HTTP and define an access list.
C. Enable SCP under the Access List section.
D. Enable HTTPS and SNMP under the Access List section.

Correct Answer: A

NEW QUESTION 7:

Which command is entered in the Cisco FMC CLI to generate a troubleshooting file?

A. show running-config
B. show tech-support chassis
C. system support diagnostic-cli
D. sudo sf_troubleshoot.pl

Correct Answer: D

Reference: https://www.cisco.com/c/en/us/support/docs/security/sourcefire-defense-center/117663-technote-
SourceFire-00.html

NEW QUESTION 8:

An organization has a Cisco IPS running in inline mode and is inspecting traffic for malicious activity. When traffic is
received by the Cisco IRS, if it is not dropped, how does the traffic get to its destination?

A. It is retransmitted from the Cisco IPS inline set.
B. The packets are duplicated and a copy is sent to the destination.
C. It is transmitted out of the Cisco IPS outside interface.
D. It is routed back to the Cisco ASA interfaces for transmission.

Correct Answer: A

NEW QUESTION 9:

A network administrator notices that SI events are not being updated. The Cisco FTD device is unable to load all of the
SI event entries and traffic is not being blocked as expected. What must be done to correct this issue?

A. Restart the affected devices in order to reset the configurations.
B. Redeploy configurations to affected devices so that additional memory is allocated to the SI module.
C. Replace the affected devices with devices that provide more memory.
D. Manually update the SI event entries to that the appropriate traffic is blocked.

Correct Answer: B

NEW QUESTION 10:

An engineer is monitoring network traffic from their sales and product development departments, which are on two
separate networks. What must be configured in order to maintain data privacy for both departments?

A. Use passive IDS ports for both departments.
B. Use a dedicated IPS inline set for each department to maintain traffic separation.
C. Use 802.1Q inline set Trunk interfaces with VLANs to maintain logical traffic separation.
D. Use one pair of inline sets in TAP mode for both departments.

Correct Answer: C

Reference: https://www.cisco.com/c/en/us/td/docs/security/firepower/640/configuration/guide/fpmc-config-guide-
v64/inline_sets_and_passive_interfaces_for_firepower_threat_defense.html

NEW QUESTION 11:

Which group within Cisco does the Threat Response team use for threat analysis and research?

A. Cisco Deep Analytics
B. OpenDNS Group
C. Cisco Network Response
D. Cisco Talos

Correct Answer: D

Reference: https://www.cisco.com/c/en/us/products/security/threat-response.html#~benefits

NEW QUESTION 12:

Which feature within the Cisco FMC web interface allows for detecting, analyzing, and blocking malware in the network
traffic?

A. intrusion and file events
B. Cisco AMP for Networks
C. file policies
D. Cisco AMP for Endpoints

Correct Answer: B

NEW QUESTION 13:

A network administrator is seeing an unknown verdict for a file detected by Cisco FTD. Which malware policy
configuration option must be selected in order to further analyze the file in the Talos cloud?

A. malware analysis
B. dynamic analysis
C. sandbox analysis
D. Spero analysis

Correct Answer: A

Reference: https://www.cisco.com/c/en/us/td/docs/security/firepower/60/configuration/guide/fpmc-config-guide-
v60/Reference_a_wrapper_Chapter_topic_here.html


Latest Complete 238 CCNP Security 300-710 Certification Exam Questions With Answers Get Lead4Pass 300-710 Exam Dumps: https://www.leads4pass.com/300-710.html (PDF+VCE)

BTW, sharing some more previous free CCNP Security 300-710 PDFs:

https://drive.google.com/file/d/1HfkLzbHVfoCRWWX1dQKg483ahxPxoQHR/

https://drive.google.com/file/d/1sLK7jCo14ta8pkXWtVqYxhJW4G6on4pR/